As per the previous post shows the paint process I was left with a orange peel rough surface.
To finish it off I wet sanded with 1200 Wet with soap. As I was flatting it back I say a few spots of primer to show through.
Worried that I was cutting back too far I switch to using a G compound instead. I had purchased G3 but they sent G6 and also G10.
As I was worried about cutting back too far I went for the G10 compound as it is a finer cutting compound.
I started 2 passes by hand and then dug out the old buffering machine. Lots of water and gentle cutting back the process started to work.
Gave a good rinse off the compound to ensure it was not left on the surface.
I then polished a wax in. I am please with the shine. Yes the reflection is still not mirror finished but could cut back again using the G6 and repeat G10 at a later date.
No comments:
Post a Comment